Mitsubishi Electric MELDAS MDS-B-SVJ2 Series Specifications And Instruction Manual page 145

No. Abbrev. Parameter name
Excessive error
SV026 OD2 detection width
during servo OFF
SSF1 Servo function
SV027
selection 1
SV028
SV029
Voltage dead time
SV030 IVC
compensation
Chapter 5 Adjustment
Set the excessive error detection width when servo ON.
For the standard setting, refer to the explanation of SV023 (OD1).
When "0" is set, the excessive error detection will not be performed.
15 14 13 12 11
aflt zrn2 ovs
bit Meaning when "0" is set
0 zup Vertical axis lift-up control stop
1
2
3
4 Set the jitter compensation No. of compensation pulses.
vfct
5 00: Jitter compensation invalid
01: Jitter compensation 1 pulse
6
7
Set the compensation amount with SV016 (LMC1) and SV041
8
lmc (LMC2).
9 00: Lost motion comp.stop
01: Lost motion comp. type 1
Set the compensation amount with SV031 (OVS1) and SV042
10
ovs (OVS2).
11 00: Overshooting comp.stop
01: Overshooting comp. type 1
12
13
14 zrn2
15 aflt Adoptive filter stops
(Note) Set to "0" for bits with no particular description.
Not used. Set to "0".
Not used. Set to "0".
When 100% is set, the voltage equivalent to the logical non-energized
time will be compensated.
Adjust in increments of 10% from the default value 100%.
If increased too much, vibration or vibration noise may be generated.
When not using, set to "0".
5-37
Explanation
10 9 8 7 6 5
lmc vfct
Meaning when "1" is set
Vertical axis lift-up control start
10: Jitter compensation 2 pulses
11: Jitter compensation 3 pulses
10: Lost motion comp. type 2
11: Setting prohibited
10: Overshooting comp. type 2
11: Setting prohibited
Set to "1".
Adoptive filter starts
Setting range
(Unit)
0 to 32767
(mm)
4 3 2 1 0
zup
0
0
0 to 200
(%)