Appendix 5Alert List - Furuno ECDIS FMD-3100 Installation Manual

APPENDIX 5 ALERT LIST
The table starting from the bottom of the page lists the possible alerts for this equipment. Each
alert is listed with alert IDs (ALF and ALR), alert description, and priority/category. This equipment
can output alerts in ALF or ALR format. The alert number depends on the output format and may
differ between formats.
This unit supports the aggregate alert function. Aggregate alerts are a grouping of similar alerts.
When an aggregated alert occurs, the aggregated alert name (header alert) is displayed on the
AMS connected to this unit. The following table lists the ALF alert numbers and aggregate alert
names that are subject to aggregate alerts.
Aggregated Alert Name
Critical Point
×=Instance number
If the alert other than "anchor watch" alert is not acknowledged within the set time (escalation
time), the alarm will sound again and the alert will be re-issued (the alert status will be repeated).
If the anchor watch alert is not acknowledged within 120 seconds after being generated, the pri-
ority changes from "warning" to "alarm". The default escalation times are as follows:
• Alerts complying with IEC 62923-2: 270 s (fixed)
• Alerts not complying with IEC 62923-2: 60 s (changeable)
• Anchor watch: 120 s (fixed)
The escalation time for "anchor watch" alerts is the time specified in IEC61174. Settings cannot
be changed.
Note 1: The priority of some alerts can be changed to "Caution". See the Operator's Manual.
Note 2: This unit's alerts are not subject to Responsibility Transfer Alerts.
Priority: Alarm, Warning, Caution
Alert No.
ALF ID ALR ID
3005,- 465
3038,1 -
to
3038,199
3038, -
100000
3003,- 985
3003,1 541
AP-24
Alert priority
Warning
Alert Name, Meaning and Remedy
Name: Invalid Datum
Meaning: Primary position sensor uses non-WGS-84 da-
tum or missing datum information.
Remedy: Check status of GPS sensor.
Name: WPT Approach XX (XX is WPT No.)
Meaning: The wheel over point has been approached.
Remedy: Take helm if needed.
Name: Critical Area
Meaning: Entering user chart notes area.
Remedy: Confirm description of notes.
Name: Lost Interface
Meaning: Data from external equipment is lost.
Remedy: Check connection of external equipment
Name: AIS MSG Send ERR
Meaning: AIS message transmission failed.
Remedy: Check the connection with AIS.
ALF No.
3038, ×
Priority/
Category
Warning/B
Warning/A
Warning/A
Caution/B
Caution/B