Furuno ECDIS FMD-3100 Installation Manual page 11

Fasten the flush mount brackets as shown below.
Pan head
screw
"A" flush mount bracket
1.1.2 Desktop mounting (optional)
You will need a Torx screwdriver (T10) and a 4mm hexagon wrench to do this proce-
dure.
1. Attach the USB cable clamp to the PCU using the supplied screws (2 pcs.).
USB cable clamp
2. Attach the brackets to the PCU-3010, referring to the figure below. It is essential
that the brackets are attached using the bottom screw holes, as shown in the
diagram below. Failure to do so will result in undue vibrations.
Note: Ensure the PCU-3010 is placed face-down on a soft, clean area to prevent
damage to the screen.
Bracket
C-washer
Flush mount bracket
Installation side
Panel PC side
Bolt
Washer
1. MOUNTING
Flat head
screw
"B" flush mount bracket
Attach the
USB cable
clamp to
these posts.
1-3