Furuno ECDIS FMD-3100 Installation Manual page 12

1. MOUNTING
3. Attach the cable clamp (supplied) to the rear of the PCU-3010 using the supplied
screws (M5×12, 3 pcs.).
4. Referring to the figure below, tilt the PCU 90° rearwards by unlocking the
brackets. Hold the unit in place, then pull and turn the locking pins clockwise, one
at a time, to set the pin in the unlock position.
5. After tilting the PCU turn the locking pin counter clockwise to lock the bracket in
place.
6. Attach the footings of the brackets in place at the mounting location using the
self-tapping screws (φ6×30, 6 pcs.) included in the mounting kit.
1-4
Cable clamp
Locking pin
Pull and turn
clockwise
Screw
Unlocked and free to move