Furuno ECDIS FMD-3100 Installation Manual page 32

2. WIRING
2.1.4 Fabricating LAN cables
Fabricate the LAN cable (FR-FTPC-CY, DTI-C5E350 VCV), as shown below. (Wrap
both edges of the armor with vinyl tape.) Confirm that the shield of the cable touches
to the shell of the modular plug.
Shielding
Cable jacket
Cover the cable jacket with insulated tape (20 mm width).
1
Expose inner sheath.
4
approx. 9 mm
Fold back drain wire and
cut it, leaving 9 mm.
7
Using special crimping tool
MPT5-8AS (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
2-8
80 250*
Inner sheath
Outer sheath
2
25 mm
Remove the sheath by
approx 25 mm. Be careful
not to damage inner shield
and cores.
5
approx. 11 mm
Straighten and flatten the
core in order and cut them,
leaving 11 mm.
1 8
[Cross cable]
WHT/ORG 1
1 WHT/GRN
2 GRN
3 WHT/ORG WHT/GRN 3
4 BLU
5 WHT/BLU WHT/BLU 5
6 ORG
WHT/BRN 7
7 WHT/BRN
8 BRN
* For flush mount installation, the
length should be based on the
installation location.
3
Fold back the shield, wrap it
onto the outer sheath and
cut it, leaving 9 mm.
6
Insert the cable into the modular
plug so that the folded part of
the shield enters into the plug
housing. The drain wire should
be located on the tab side of
the jack.
Modular plug
1 WHT/ORG
2 ORG
ORG 2
3 WHT/GRN
4 BLU
BLU 4
5 WHT/BLU
6 GRN
GRN 6
7 WHT/BRN
8 BRN
BRN 8
approx. 9 mm
Drain wire
[Straight cable]
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8