Furuno ECDIS FMD-3100 Installation Manual page 15

3. Using the cutouts in the hood, set the hood in place between the knobs and the
hood fixing fixtures.
Cutouts
4. Referring to the figure below, push the hood down to align the cutouts with the
knobs.
5. Fasten the knobs to secure the hood in place.
1.1.4 How to install the keyboard (optional)
For OP24-41
To install the optional keyboard (Type: 5139U BLACK, contained in OP24-41), do the
following procedure.
1. Stick the smaller velcro tape (Fastener, 4 pcs., supplied with the optional kit) to
the four corners of the rear of the keyboard.
2. Fit the larger velcro tape (Fastener, 4 pcs., supplied with the optional kit) to the
smaller tape.
3. Remove the protective film from the larger velcro tape.
4. Fit the keyboard at the installation location.
Hood
Push downwards
1. MOUNTING
Hood fixing fixture
(left and right)
Cutouts
1-7