Furuno ECDIS FMD-3100 Installation Manual page 14

1. MOUNTING
1.1.3 How to attach the hood (optional)
Follow the procedure below to install the optional hood (type: OP24-60). You will need
these tools.
Flush-mounting: T25 Torx screwdriver
Desktop mounting: 4 mm hex wrench
1. Referring to the figure below, fit the hood reinforcement fixture to the back of the
PCU-3010.
Flush-mounting: Install the hood fixing fixture with the flush mount brackets.
Desktop mounting: Install the hood fixing fixture with the desktop mount
brackets.
Note: The screws and washers to fix the hood fixing fixture are supplied with the
PC-3010.
Flush mount
2. Screw in knurled knobs (4 pieces) loosely from the inside onto the embedded
bolts of the hood fixing brackets (2 pieces).
1-6
Flush mount bracket
Hood fixing fixture
Knob
Desktop
Hood fixing bracket
: Embedded bolt : Embedded bolt
Desktop
mount
bracket
Hood fixing
fixture