Configuring Volt 100 Series; Configuring With Surveyor; Configuring With The Cpiaddmodule() Instruction; Configuring With Device Configuration Utility - Campbell GRANITE VOLT Series Product Manual

9.3 Configuring VOLT 100 series

The VOLT 100 series arrives ready to be connected to a system. Device configuration is only
required when multiple GRANITE Measurement Modules are connected to a single data logger.
Each module must have a unique address. Set a unique device name for further distinction
between GRANITE Measurement Modules.
Configure the VOLT 100 series using one of four methods: through SURVEYOR, the
CPIAddModule()
table.

9.3.1 Configuring with SURVEYOR

Modules are automatically configured when connected to SURVEYOR. SURVEYOR sets the
module CPI address to 1 and uses the device type and serial number to generate and assign a
device name such as 'VOLT108-1234'.
For more information see

9.3.2 Configuring with the CPIAddModule() instruction

To configure a VOLT 100 series within a program, use the
separate instruction is used for each device. The
settings entered by other means, such as Device Configuration Utility or the CPIStatus table.
CPIAddModule
(CDMType, CDMSerialNo, CDMDeviceName, CPIAddress)
The data logger creates an internal list of CPI modules from each
instruction. Modules added to the CPI bus will be checked against this list and reconfigured
accordingly. See a programming example:
CPIAddModule() (p. 45).
NOTE:
The CPIAddModule()
Configuration Utility or the CPIStatus table.

9.3.3 Configuring with Device Configuration Utility

Install the device driver before connecting the VOLT 100 series to a computer. This is optional for
Windows 10, or later, operating systems.
program instruction, Device Configuration Utility software, or the CPIStatus
Measurement quickstart using SURVEYOR
instruction overrides changes made through SURVEYOR, Device
CPIAddModule()
CPIAddModule()
Configuring GRANITE Measurement Module with
(p. 2)
instruction. A
instruction overrides
CPIAddModule()
VOLT 100 series 23