Infrared Led Illuminators Installation; Fitting The Bracket; Fitting The Illuminator On The Bracket - Videotec ULISSE NETCAM Instruction Manual

Uuunit fot network cameras
Hide thumbs Also See for ULISSE NETCAM:
Table of Contents

Advertisement

Available languages

Available languages

7.1.4 Infrared LED illuminators
installation
Together with the bracket supplied as
standard, the pan & tilt is preset for the
installation of 2 VIDEOTEC LED infrared
illuminators.
To work properly both illuminators must be
installed together.

7.1.4.1 Fitting the bracket

Position the bracket (01) on the bottom of the
housing as shown in the illustration. Install the screws
and the washers (02) in the holes (03) and tighten
them. Make sure the bracket is fastened down firmly.
Use only the material supplied with the kit.
03
01
02
Fig. 18
Pay attention to the fixing. Tightening
torque: 4Nm.
18

7.1.4.2 Fitting the illuminator on the bracket

Place the fixings of the illuminator (01) on those of
the bracket (02).
Fig. 19
Insert the 16mm screws and washers.
03
Fig. 20
02
Pay attention to the fixing. Tightening
torque: 6Nm.
01
01
02

Advertisement

Table of Contents
loading

Table of Contents