Digital I/O; Washer - Videotec ULISSE NETCAM Instruction Manual

9.1.11 Digital I/O

In the Digital I/O tab it is possible to configure the
digital channels available in Pan & Tilt. What follows is
a brief description of the configurable parameters for
each digital input.
• Alarm ID: Field used to select the desired digital
input.
• Type: It indicates the default state of the digital
input. It can be set Normally Open or Normally
Closed.
• Action: Each input can be associated with an
action. The action is activated when the contact is
in a state other than default. The available actions
are listed below:
• NONE: No action.
• SCAN: Position the pan & tilt on the selected
preset.
• PATROL: Activate the PATROL.
• AUTO-PAN: Activate AUTOPAN.
• WIPER: Activate the Wiper.
• WASHER: Activate the glass cleaning sequence.
• RELAY 1: Activate Relay 1.
• RELAY 2: Activate Relay 2.
• IR FILT: Deactivate the camera's IR Filter. If
available, it turns on the infrared illuminators.
To check correct operation of the alarms, a dot will
appear on the web page. The dot will be green
in normal conditions and red when an alarm is
detected.
Fig. 71

9.1.12 Washer

The Pan & Tilt wash pump is configured in the Washer
tab where it is possible to associate a preset to the
washing operation, set the duration of washing and
specify the wiper on/off delay.
Fig. 72
35