Lenovo ThinkSystem D2 Manual page 206

Severity: Warning
User Action:
1. Restart BMC via supported method and reboot the system.
2. If the problem persists, reflash BMC firmware.
3. Retry OS deployment.
4. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
5. If the problem persists, contact technical support.
• FQXPMOS0007K: Failed to read License RTF file.
Severity: Warning
User Action:
1. Restart BMC via supported method and reboot the system.
2. If the problem persists, reflash BMC firmware.
3. Use another OS media (USB DVD or USB key).
4. Retry OS deployment.
5. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
6. If the problem persists, contact technical support.
• FQXPMOS0008K: Make sure the Ethernet cable has been plugged into your computer and your
network settings are correct.
Severity: Warning
User Action:
1. Ensure proper operation of SMB/CIFS and NFS communications (make sure the Ethernet cable has
been plugged and network settings are correct.).
2. Make sure the OS version and folder path are correct.
3. Retry CIFS and NFS installation.
4. If the problem persists, contact technical support.
• FQXPMOS0009K: Current System Boot Mode is Legacy. LXPM OS installation only support UEFI
Mode.
Severity: Warning
User Action:
1. Change boot mode to UEFI mode
2. Retry OS deployment.
• FQXPMOS0010I: Red Hat RHEL 7.3 (64-bit) OS installed
Severity: Info
User Action:
202
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute
Node Messages and Codes Reference