Lenovo ThinkSystem D2 Manual page 181

Severity: Warning
User Action:
Complete the following steps:
1. Check system spec and follow the rules for populating DCPMM in correct order.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFMA0041K: Near Memory/Far Memory ratio (1:[arg1].[arg2]) for Intel Optane DCPMM
configuration is not in recommended range (1:2 - 1:16).
Severity: Warning
User Action:
Complete the following steps:
1. Validate system's memory configuration by using the memory configuration tool below: https://dcsc.
lenovo.com/#/memory_configuration.
2. Resolve DIMM configuration so that the DCPMM ratio meets firmware requirements, then reboot the
system.
• FQXSFMA0042K: Intel Optane DCPMM is not supported by processor of this system.
Severity: Error
User Action:
Validate system's memory configuration by using the memory configuration tool below: https://dcsc.
lenovo.com/#/memory_configuration.
• FQXSFMA0047M: SPD CRC checking failed on DIMM [arg1]. [arg2]
Severity: Warning
User Action:
Complete the following steps:
1. Perform a virtual reseat or AC cycle the server.
2. If the problem returns Collect Service Data log.
3. Contact Lenovo Support.
• FQXSFPU0001N: An unsupported processor has been detected.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo support site for a firmware update required for this processor and install that update, if
applicable.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFPU0002N: An invalid processor type has been detected.
Severity: Error
User Action:
Complete the following steps:
. 177
Chapter 4 UEFI events