Lenovo ThinkSystem D2 Manual page 128

User Action:
Make sure that the correct login ID and password are being used.
• FQXSPSE4005I: Remote access attempt failed. Invalid userid or password received. Userid is
[arg1] from TELNET client at IP address [arg2].
This message is for the use case where a user has failed to log in to a Management Controller from a
telnet session.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0019
User Action:
Make sure that the correct login ID and password are being used.
• FQXSPSE4007I: Security: Userid: [arg1] using [arg2] had [arg3] login failures from an SSH client at
IP address [arg4].
This message is for the use case where a user has failed to log in to a Management Controller from SSH.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0041
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the correct login ID and password are being used.
2. Have the system administrator reset the login ID or password.
• FQXSPSE4008I: SNMPv1 [arg1] set by user [arg2]: Name=[arg3], AccessType=[arg4], Address=
[arg5], .
A user changed the SNMP community string
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0075
User Action:
Information only; no action is required
• FQXSPSE4009I: LDAP Server configuration set by user [arg1]: SelectionMethod=[arg2],
DomainName=[arg3], Server1=[arg4], Server2=[arg5], Server3=[arg6], Server4=[arg7].
A user changed the LDAP server configuration
Severity: Info
Serviceable: No
124
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute
Node Messages and Codes Reference