Lenovo ThinkSystem D2 Manual page 192

• FQXSFPU4081I: Host Power-On password has been cleared.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4082I: Host Admin password has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4083I: Host Admin password has been cleared.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4084I: Host boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4085I: Host WOL boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPW0001L: CMOS has been cleared.
Severity: Warning
User Action:
Complete the following steps:
1. If the CMOS clear was user initiated this event can be safely ignored and no further action is required.
2. If the system was recently installed, moved, or serviced, make sure the battery is properly seated.
3. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this
error.
4. If the problem persists, collect Service Data logs.
5. Contact Lenovo Support.
• FQXSFSM0002N: Boot Permission denied by Management Module: System Halted.
Severity: Warning
User Action:
Complete the following steps:
1. Check XCC logs.
2. Review power policies and system configuration settings in the XCC GUI.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
188
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute
Node Messages and Codes Reference