Table of Contents
Advertisement
4.
Using a 5mm hex wrench, remove the belt
cover by pulling the four cap screws (figure
66).
figure 66. Belt cover removal.
5.
Using a 17mm wrench, loosen the lock bolt,
use the belt tension lever to de-tension the
belt, then remove the belt.
6.
install a new belt.
-42-
7.
Belt Cover
8.
push firmly and hold the belt tension lever
toward the rear of the machine and re-tighten
the lock bolt (figure 67). no belt deflection is
required.
Lock Bolt
& Belt
tension
Lever
figure 67. V-belt tension lever.
re-install the belt cover, the belt access
plate, and return the headstock to the vertical
position.
model g0695 (mfg. since 9/10)
Advertisement
Table of Contents
