Operation Overview; Table Movement - Grizzly G0695 Owner's Manual

Operation Overview

this overview gives you the basic process that hap-
pens during an operation with this mill. Familiarize
yourself with this process to better understand the
remaining parts of the Operation section.
To complete a typical operation, the operator
does the following:
1. Loosens the knee lock, and adjusts the
table height to ensure there is sufficient
room to install the tooling in the quill and the
workpiece on the table.
2. installs correct tooling for the task.
3.
mounts the workpiece securely to the table
using a vise or clamps.
4. selects the appropriate spindle speed for the
workpiece and tooling.
5. selects the direction the spindle will turn,
based on the type of cut needed, using the
direction switch.
6.
Unlocks the X- and y-axis table locks, then
secures the z-axis lock.
7. Wears safety glasses or a face shield.
8. starts the machine.
9. adjusts the spindle height.
10. For milling operations, uses the X-axis
handwheel to move the table left-and-right
and uses the y-axis handwheel to move the
table in-or-out, so the cutter removes material
evenly from the workpiece.
For drilling operations, uses the coarse
downfeed lever or fine downfeed handle to
lower the tooling into the workpiece, then
raises the tooling out of the workpiece.
11. presses the stop button to stop the spin-
dle.
-22-

Table Movement

this mill table has three paths of movement con-
trolled by the corresponding handwheels or crank
(see figure 17):
1.
Left–right (X-axis)
2. in–out (y-axis)
3. Up–down (z-axis)
X-Axis
or Left & Right
Z-Axis or
Up & Down
figure 17. the three movement paths of the mill
table.
the graduated dials are marked in increments
of 0.001", with a full revolution of the handwheel
moving the table 0.125".
model g0695 (mfg. since 9/10)
Y-Axis or
In & Out