Table of Contents
Advertisement
Spindle break-In
it is essential to closely follow the proper break-in
procedures to ensure trouble-free performance of
your mill.
NOTICE
DO NOT leave the area while the break-
in procedure is under way. you must be
ready to stop the machine if any problem
occurs.
NOTICE
Successfully complete the spindle break-in
procedure to avoid rapid wear of spindle
components when placed into operation.
-18-
To perform the spindle break-in procedure:
1.
turn the machine ON, then use the speed
dial to adjust the spindle speed to approxi-
mately 200 rpm.
2.
Let the mill run at this speed for 20 minutes,
then turn the spindle OFF and wait for it to
stop.
3.
Use the spindle direction switch on the con-
trol panel to reverse the spindle direction,
then turn the mill ON and let it run for another
20 minutes.
4.
set the spindle speed at approximately 1800
rpm, repeat Steps 2–3, then proceed to
Step 5.
5.
turn the mill OFF. the spindle break-in is
now complete and the machine is ready for
operation.
model g0695 (mfg. since 9/10)
Advertisement
Table of Contents
