Grizzly G0695 Owner's Manual page 38

NOTICE
failure to follow the lubrication practices
outlined in this manual could lead to pre-
mature failure of your mill and void the war-
ranty.
One-Shot Oiler
Lubricant
iso 68 Lubricant or
Equivalent
the oil lines running from the one-shot oiler feed
lubrication to the ways of the column (knee),
saddle, and table.
Use the sight glass on the front of the oiler to make
sure it is full, then pull the handle (see figure 54)
and release it to send lubricant through the lines.
Fill Cap
figure 54. one-shot oiler.
-36-
frequency Qty
Every 1
8 hours pump
of operation
oil Line
one-shot
pump
handle
Quill Gearing
Lubricant
iso 68 Lubricant or
Equivalent
Lift the cap of the oil cup shown in figure 55 to
add the lubricant.
Quill gearing
oil Cup
figure 55. Quill gearing oil cup.
Vertical bevel Gears
Lubricant
nLgi #2 grease
raise the knee up to access the vertical bevel
gears underneath the saddle, then clean and
lubricate the bevel gears shown in figure 56.
Bevel gears
figure 56. Vertical bevel gears.
model g0695 (mfg. since 9/10)
frequency Qty
Every 5
8 hours drops
of operation
frequency Qty
Every thin
40 hours Coat
of operation