Table of Contents
Advertisement
Downfeed Controls
refer to figures 15–16 and the following descrip-
tions to understand the functions of the downfeed
controls that affect the travel of the quill, spindle,
and cutter.
A. Quill Dog: moves with the quill. Use the
pointer on the side of the dog with the
downfeed scale to determine the depth of
downfeed.
b. Downfeed Scale: displays in
the amount of quill travel.
C. Coarse Downfeed Handle: When this han-
dle is enabled with the downfeed selector, it
raises/lowers the quill quickly.
D. Quill Lock: Locks the quill in place but does
not affect spindle rotation.
E. Downfeed Stop & Lock: stops downfeed
travel when the quill dog reaches this point. set
the stop at any position along the downfeed
scale, then secure it in place by tightening the
lock up to it.
a
E
figure 15. downfeed controls viewed from the
right side.
model g0695 (mfg. since 9/10)
f.
G. fine Downfeed Handwheel: When this
H. Downfeed Selector: When rotated, enables
⁄
" increments
1
8
B
C
d
Graduated Scale: displays quill travel in
0.001" increments when the fine downfeed
handwheel is used. one full revolution of the
handwheel represents 0.080" of quill travel.
handwheel is rotated with the downfeed
selector, it raises/lowers the quill in small
increments.
either coarse or fine downfeed control. tighten
the selector to engage the fine downfeed
handwheel, and loosen it to engage the
coarse downfeed handle.
g
h
F
figure 16. downfeed controls viewed from the
left side.
-21-
Advertisement
Table of Contents
