Table of Contents
Advertisement
Available languages
Available languages
FULLMOON
9
3.4 AUTO SHOW MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MODE until appears on the display [AUTO].
• Press the button SETUP to select programs [n.001 - n.100] with the buttons UP/DOWN.
• Press the button SETUP to select the speed of execution [SP01 -SP99-SPFL] with the buttons UP/DOWN.
• Press the button SETUP to select the flash frequency [FS01 - FS99] with the buttons UP/DOWN.
3.5 PROGRAMS
To select the preset programs:
• Press the button MODE until appears on the display [Pr01].
• Press the buttons UP/DOWN to select the programs [Pr01 - Pr12].
• Press the button SETUP to select the speed execution [SP01 - SP99 - SPFL] with the buttons UP/DOWN.
• Press the button SETUP to select the flash frequency [FS01 - FS99] with the buttons UP/DOWN.
3.6 SOUND MODE
• To enter in sound mode; press button MODE until appears on the display [SO01].
• Press the button SETUP to select [SO00 - SO31] with the buttons UP/DOWN.
3.7 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as
the Master. The unit must be the first unit in line; other units will work as slave (SLAV) with the same effect.
• Press the button MODE until appears on the display [SLAV].
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For the longer cable runs we suggest a terminator at the last fixture (see page 10).
3.8 DMX MODE
• Press the button MODE until appears on the display [d.001]
• Press the buttons UP and DOWN to select the value desidered (001-512) and press the button SETUP.
The tables on page 11 indicate the operating mode and DMX value
3.9 DMX ADDRESSING
To able to operate the FULLMOON with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX chan-
nel, adjust the start address 33 on the FULLMOON. The other functions of the light effect panel are then
automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
Start address
DMX Address
Next possible start
Next possible start
Next possible start
DMX channels
(example)
occupied
address for unit No. 1
address for unit No. 2
address for unit No. 3
3
33
33-35
36
39
42
Advertisement
Chapters
Table of Contents
