Auto Show; Static Mode; Master/Slave Mode; Linking - ProLights DISPLAYCOBTRWDWW User Manual

10

3.4 AUTO SHOW

If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows Auto Show, then press the button ENTER.
• Press the button UP/DOWN to switch between the show Auto 1 - Auto 3. The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast 0-100.
• Press the button ENTER to save the setting.
IMPORTANT: Programs Auto 1 - 3 are fully pre-programmed and will not be altered by changes. Instead,

3.5 STATIC MODE

This fixture has the ability to accept custom static color settings. Access this via the control panel.
• To enable the static mode, press MENU repeatedly until Static shows on the display.
• Through the button UP/DOWN select Dimmer or Strobe then press the button ENTER.
• Set the value (000 - 255), through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 12).
• Set on master fixture the desired program (see section 3.4).
• Set the slaves to the same DMX modes.

3.7 LINKING

1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.8 DMX MODE

• Press the button MENU so many times until shows 1 Ch, 2 Ch or 5 Ch and press the button ENTER to con-
firm.
• Press the button UP/DOWN to select the desired DMX address 001 - 512. Press and hold to scroll quickly.
Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
The tables on page 13 indicate the operating mode and DMX value. DISPLAYCOBTRWDWW is equipped
with 5-pole XLR connections.

3.9 DMX ADDRESSING

To able to operate the DISPLAYCOBTRWDWW with a light controller, adjust the DMX start address for the
first a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first
DMX channel, adjust the start address 33 on the DISPLAYCOBTRWDWW. The other functions of the light
effect panel are then automatically assigned to the following addresses.
diSpLAYcoBTRWdWW