Table of Contents
Advertisement
PSS-106 Battery Speaker
6.
Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is designed to be used as a wireless loudspeaker. It is suitable only for indoor use. This device is
not suitable for households.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Start-up
To operate the device:
Make sure that all PSS-106 and all external devices are switched off.
Connect all devices. See 5.7. Setup Examples on pages 18–19 for more information.
Switch on the audio mixer.
Switch on the PSS-106 devices. See 5.2. Switching the PSS-106 On/Off on page 17 for more
information.
Turn up the volume controls on the PSS-106 devices. See 6.5. 3-channel Mixer, 6.6. Wireless
Microphone Receiver and 6.7. Media Player on pages 21–23 for more information.
Use PFL (Pre-Fade Listen) to set the proper input level for the audio amixer and set the main mix level.
After use, switch off the PSS-106 devices. See 5.2. Switching the PSS-106 On/Off on page 17 for more
information.
Switch off the audio mixer.
6.3.
LED Statuses
There are 3 LED indicators (Signal/Clip indicator (20), Power indicator (22) and Recharge indicator (24)
and) on the 3-channel mixer (02). The LED indicators have the following functions:
●
SIGNAL/CLIP:
●
If the light is green, the output is within the normal range.
●
If the light is red, the output is too high. Decrease the volume on the device/instrument/audio
mixer.
●
RECHARGE:
●
If the light is red, the battery is being charged.
●
If the light is green, the battery is charged.
●
POWER: If the light is on, the device is powered.
Product code: D2612/D2613
20
Advertisement
Table of Contents
