Installation; Set Up And Operation; Connection; Ac Power - DAPAudio D2608 Manual

PSS-108 MKII

Installation

Remove all packing materials from the PSS-108 MKII. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
Do not attempt to operate an 115V specification product on 230V power, or vice versa.

Connection

01) Press the power (28) switch to turn off the device.
02) Connect the PSS to the other devices which you plan to use.
CAUTION: Make sure that the power is off, when connecting the cables.

AC Power

01) Make sure the power (28) switch is in off position.
02) Connect the power cable.
03) Press the power (28) switch to turn the PSS on. The power (14) LED will light up in red.

Battery Operation

01) Switch the power (28) switch to on position.
02) When pausing playback, switch the power (28) switch to the Off position to save your batteries.
03) If the batteries are fully charged, the PSS can run on battery power for approximately 3-5 hours,
depending on the volume level.
04) If the batteries run low and/or the orange LED of the battery level indicator (12) lights up, please turn
the PSS off and recharge the battery.
Note:
The battery in the PSS should not be fully depleted. Charge it when it is low, but do not let it drain fully.
On the other hand, constant top off charging of a battery is never good.
Any charging adds heat which degrades a battery. Storage in a cool place slows the aging process of
lithium-ion. Manufacturers recommend storage temperatures of 15°C.

Charging the Built-in Battery

01) Make sure the power (28) switch is in off position and connect the power cable.
02) Press the power (28) switch to charge the PSS's internal battery.
03) While the PSS is charging, the red recharge (13) LED will light up in red.
04) Charge the battery for at least 8 hours. If the battery is fully charged, the red recharge (13) LED will
light up.
Ordercode: D2608
10