Table of Contents
Advertisement
PSS-106 Battery Speaker
Bluetooth Mode
Attention
Bluetooth can be used only for receiving of wireless audio signals.
Bluetooth can only be used as a means to receive wireless audio signals. It is not possible to pair the
device with other devices via Bluetooth.
For this control mode to work, you need to pair your mobile device and the receiver via Bluetooth.
See 5.6. Pairing Mobile Devices with the Receiver via Bluetooth on page 18 for more information. Press the
MODE button (36) until the display (35) shows BT.
●
Repeatedly press the FORWARD/VOLUME + and BACKWARD/VOLUME – (37/39) buttons to select
tracks backward/forward.
●
Press and hold down the FORWARD/VOLUME + and BACKWARD/VOLUME – (37/39) buttons to
decrease/increase the volume. The adjustment range is 0–27, from low to high volume.
●
Press the PLAY/PAUSE button (38) to play the currently selected track. Press the button again to
pause the playback.
Note: When your mobile device receives an incoming call, press the PLAY/PAUSE button (38) to answer
the call. When the conversation is finished, press the button again to end the call and return to Bluetooth
mode.
7.
Troubleshooting
This troubleshooting guide contains solutions to problems which can be carried out by an ordinary
person. The device does not contain user-serviceable parts.
Unauthorized modifications to the device will render the warranty void. Such modifications may result in
injuries and material damage.
Refer servicing to instructed or skilled persons. Contact your Highlite International dealer in case the
solution is not described in the table.
Problem
The device does not
function at all
No sound
Bursts of noise or
other audible signals
present
Momentary loss of
sound as the device
is moved around
performing area
Product code: D2612/D2613
Probable cause(s)
No power to the device
The battery is depleted
Devices are not paired
Bad connections
Sources of interference are present
Dead spots are present
Solution
●
Check if the device is switched on
●
Make sure the batteries are inserted
properly into the wireless microphone
●
Replace the batteries with new ones
●
Recharge the battery. See 4.5. Charging
the Battery on page 15
●
Check if the device and external
devices are paired
●
Check if the connections between the
device and external devices are correct
●
Identify potential sources of interference
(other RF-sources) and turn them off
●
Reposition the device and perform a
walk-through test again. If audible drop-
outs persist, mark the dead spots and
avoid them during performance
24
Advertisement
Table of Contents
