Table of Contents
Advertisement
4.C. Switching On the Maxwell
Once all the foam pieces have been removed and the Tablet PC set up, you can connect the instrument to a
power outlet. The power switch is located next to the power cable connection on the back of the instrument.
Ensure that the On/Off switch is in the off position. Plug the power cord into a wall outlet. See Section 1.E.
for power requirements. We recommend connecting the Maxwell
Switch instrument on using the On/Off switch. Connect the Tablet PC power cord into a wall outlet.
Press the Tablet PC power switch located on the top of the Tablet PC to turn the Tablet PC "ON". Every time
the software is started, it will perform a self-diagnostic test. The deck, plunger bar and magnetic rod
assembly are moved to check operation.
Figure 14. On/Off Switch.
4.D. Shutting Down the Maxwell
Shut Down Instrument
1.
Shut down the software by pressing the X in the upper left corner of the 'Home' screen (Figure 15).
2.
Shut down the Tablet PC using normal Windows
tablet screen, touch Settings, touch Power, touch Shut Down).
Note: The Tablet PC must be shut down at least once a week to allow Windows
!
usage.
Promega Corpora on · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · 608-274-4330 · Fax 608-277-2516
www.promega.com
®
CSC Instrument
®
CSC Instrument
®
CSC to an uninterruptible power supply.
®
8 shut down procedure (swipe in from right side of
®
to reset memory
TM424 · Revised 2/15
17
Advertisement
Table of Contents
