Polycom DMA 7000 Getting Started Manual page 9

System Configuration
Information
Default IPv4 gateway
System Time
Time zone
NTP server #1
NTP server #2
NTP server #3
Routing Configuration
Destination
Length
Interface
Via
Polycom, Inc.
My System Values
® ™
Polycom DMA
Description
In split network configuration, select which
of the two networks' gateway servers is
the default.
Your choice depends on your network
configuration and routing. Typically, unless
all the endpoints, MCUs, and other
devices that communicate with the system
are on the same subnet, you'd select the
signaling network.
Time zone in which the system resides.
IP address of the primary NTP time server
(optional, but strongly recommended).
IP address of a second NTP time server
(optional).
IP address of a third NTP time server
(optional).
If you know you need to set up a special
network routing rule or rules, specify the
information below for each rule.
In a split network configuration, routing
rules are necessary for proper routing of
network traffic.
The destination network mask for this
route.
The destination CIDR subnet.
In split network configuration, specify the
interface for this route.
IP address of router for this route.
Optional, and only needed for non-default
routers.
System Server Setup
5