Alternate Procedure: Configure The Polycom Dma System Server(S); Without Using The Usb Stick - Polycom DMA 7000 Getting Started Manual

Alternate Procedure: Configure the Polycom DMA System
Server(s) Without Using the USB Stick
Polycom, Inc.
Refer to the online help or the Polycom DMA Operations Guide for the
relevant descriptions and procedures.
If for some reason you don't have or can't use the Polycom DMA USB
Configuration Utility on the USB memory stick, the following procedure
enables you to complete the initial setup using only a laptop PC and an
Ethernet cable.
This is possible because Polycom DMA system servers are shipped with
default network settings that you can use to connect to the system. The settings
are:
IP address: 192.168.1.101
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
To configure the Polycom DMA system server(s) using a laptop PC
Follow the unpack and install procedure
1
connect the server(s) to the enterprise network.
Configure the network settings on your laptop to put it on the same
2
network segment as the Polycom DMA system server(s) (see the server's
default settings above). For instance, you can use the following settings:
IP address: 192.168.1.20
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
Connect an Ethernet cable between your laptop and the GB 1 interface of
3
the first (or only) server (the one you want configured as Node 1).
You can use the cable that will later connect the server to the switch
(enterprise network). Be sure you connect to the server's GB 1 interface,
not the GB 2 or GB 3 interface.
On the laptop, point your browser to http://192.168.1.101 (if a
4
security certificate warning appears, ignore it) and log in with user ID
admin and password admin.
The Polycom DMA system's management interface appears, displaying
the Dashboard.
Go to Configuration > System > Network, enter the network values (and
5
routing configuration, if necessary) from the
® ™
Polycom DMA System Server Setup
(page 6) through step 7. Do not
First-Time Setup Worksheet,
11