Polycom DMA 7000 Getting Started Manual page 13

Polycom, Inc.
Under NTP servers, enter the IP addresses (or domain names) for the
c
time servers from the
We strongly recommend specifying at least one and preferably three
time servers. Use NTP stratum 3 quality time servers, if possible.
Click Done.
9
The utility confirms that the configuration file was created and returns
you to the initial menu.
10 Verify that the initial menu now states that The USB stick is set to apply
system parameters.
11 Close the program.
12 In your system tray, click Safely Remove Hardware and select Safely
Remove USB Mass Storage Device. When a message tells you it's safe to
do so, disconnect the USB memory stick from the PC.
The Polycom DMA system software is already installed on the server(s), so the
system installation disk isn't needed to set up a new system. Using it overwrites the
same software already on the server and needlessly lengthens the setup process.
Put the disk away in a safe place in case it's ever needed to restore the system.
13 Make sure that both servers are off.
Polycom
First-Time Setup Worksheet.
® ™
DMA System Server Setup
9