Direct Rtp For H323 Terminals; Inter-Node Protocol H323; Pre-Login (V120); Starting Up The Cpu In Its Environment On Site - Alcatel-Lucent OmniPCX Enterprise Manual

INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
G723 can only do 30 ms.

16.5.3 Direct RTP for H323 terminals

This parameter must be set to No if a only one H323 terminal of the installation does not support the
direct RTP

16.5.4 Inter-node protocol H323

The H323 Inter-node protocol parameter must be set to Yes in all nodes of the sub-network.
In an OmniPCX Enterprise R10.0 system, this parameter is removed (validated by default).

16.5.5 Pre-login (V120)

As of Release 5.1, the pre-login path as changed as regards Unix versions. It is located under the
DHS3bin/servers or usr2/servers directory.

17. STARTING UP THE CPU IN ITS ENVIRONMENT ON SITE

Do not proceed by switchover.
Proceed with a complete system start-up in order to download the new firmware of the couplers.

17.1 Downloading the couplers and sets

The first start-up of the CPU in its site environment requires particular attention since the couplers will
be downloaded with a new firmware.
−
To download the INT1B couplers, they must be removed from the secondary ACTs and put in
place of the INT1A couplers of the main ACT.
− Use the downstat command to monitor the evolution of the coupler downloading. The CPU
ensures 25 downloads simultaneously. The state of a coupler during downloading is RUNNING
1.
It is possible to program an automatic reset of the couplers with the option 'r'.
− Reset manually the UA32 or eUA32 boards of shelf 0 if they do not start (do not concern
OmniPCX Enterprise with common hardware or controlled by an Appliance Server).
−
Use the downstat i command to monitor the evolution of IP Phones (e-Reflexes, IP Touch
series 8) downloading.
− Use the downstat t command to monitor the evolution of IP Touch TDM (series 9)
downloading.
17.2 Sites with the "IP Touch Security" feature: Migration from R6.2 or R7.x to R10.0
with SSM & MSM boxes in version 1.3.xx
CAUTION
Sites using "IP Touch Security Solution" feature (Encryption) must follow a specific procedure to
update the IP Touch security boxes.
Ed. 02 / 22 June 2011
OmniPCX Enterprise
57 TC1449