Save And Restore On Usb Key; Passive Communication Server - Alcatel-Lucent OmniPCX Enterprise Manual

INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
− CPU6 Step2 functions at 100 Mbits Full Duplex.
− You can manage the mode and the rate CPU7 boards. The setting of CPU7 board and of the
port of the switch on which the CPU7 board is connected, must be the same.
− The use of hard key is always available on CPU6 but not on CPU7.
− The CPU7 board does not support the OBCA daughter board.
− The CPU7 board the IO2 board. Only the IO2N boards are authorized.
− The CPU7 board is not allowed in a VH cabinet.
− USB port for Data Backup and restoration.
USB ports on CPU7-2, Appliance Server and Blade Center IBM are usable to connect a USB key
for the backups and restorations of the databases, Linux data and OPS via swinst .
2.5.

Save and restore on USB key

USB keys are compatible as of Release 7.1 with CPU7-2, Appliance Server and Blade Server only.
The USB connector of CS-2 CPU board is unused.
Note
Hard disk on USB is not supported.
2.6.

Passive Communication Server

A CS board configured as Passive Communication Server must be equipped with a 256 MB SDRAM.
Reference for CS equipped with a 256 MB SDRAM used as PCS: 3EH 73048 BBAB.
As of Release 8.0, for an installation equipped with PCS and with more than 5000 users (physical
sets), Actis configures necessarily these PCS in Appliance Servers. This restriction is removed with
Release 9.0 and Actis 13.6 which authorize the possibility to use CS-2 boards.
If updating the software (patch or complete version) of a system equipped with PCS, it is necessary to
update the PCS before updating the version of the Central Com Server (constraint related to
database compatibility).
If updating the software of PCS, it is necessary to check that this update does not start in the period
of automatic re-synchronization of the database on the PCS (especially if the method used is the
scheduled Remote Download) because this re-synchronization involves an automatic reboot of the
PCS.
When SIP set switches on PCS:
− It has to register again as the Call Server registar database is not replicated on the PCS.
− If it is in dynamic mode, a local DHCP server is required.
Ed. 02 / 22 June 2011
OmniPCX Enterprise
9
APPENDIX 2
REMARKS & RESTRICTIONS
TC1449