Saving Actis Files In The Image Of The Site; Saving The Lanpbx.cfg File; Operating Mode; New Installation - Alcatel-Lucent OmniPCX Enterprise Manual

As the IP addressing plan has changed since Release 3, it is not possible to reuse the Chorus data
from a previous version in its current state.
The restoration of Chorus data from a release lower than 3.0 is possible only in the case of a
intermediate translation in Release ≤ R5.0.1 Ux. A translation is then carried out including the names
and addresses of the CPU and its twin, addressing by role, the local tunnel, SLIP management and
"trusted hosts".
The translation of the tunnel creates static LCNs. For a network where all nodes are in R7.1, the
static LCNs must be deleted.
9.6

Saving Actis files in the image of the site

It is essential to save the site OPS files (photoconfig). They will be required to be able to carry out
a migration to R10.0.
9.7

Saving the lanpbx.cfg file

If the lanpbx.cfg file was used in Release 3.2, it is essential to save it before passing to Release 10.0
(usr2/downbin/lanpbx.cfg). It should be restored after the translations in usr3/mao.
If forgotten, this file should be recreated.
For more information, refer to the System documentation (Functional documentation/IP-PCX
networks/IP Phones section).
Refer to the technical communication
Phones attached to networked OmniPCX

10. OPERATING MODE

10.1 New installation

New installations are not dealt with in this document, since in this case all the products delivered and
installed will be in the correct editions and compatible.
Particular attention should be paid in the case of networking.
See paragraphs 6 and

10.2 Updating R5.1.x, R6.x, R7.x, R8.0.x, R9.x to R10.0

After updating to R10.0, you will find the same level of functionalities as initial release.
However, certain applications require a minimum version, see paragraph
All the elements required for passage to R10.0 are given in paragraphs 7 to 16.
REMINDER
It is mandatory to reconfigure the system by Actis even if there is no changing of license or
hardware.
TC1449
OmniPCX Enterprise
TC0150 Configuring the OmniPCX 4400 as "boot server" for IP
4400.
7 .
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
46
7.9 .
Ed. 02 / 22 June 2011