Installation Of Release 10.0 In Network With Releases 5.1.X, 6.X, 7.X And; Installation Of Release 10.0 In Network Releases 8.0.1, 9.0 And 9.1 - Alcatel-Lucent OmniPCX Enterprise Manual

INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
As of Release 7.0, the number of entities and IP domains changes to 1000 (in
Releases < 6.2, the number of entities is 255 and the number of IP domains is 128).
In a network, these limits are allowed only if each node of the network is in Release
6.2 or higher.
In Release 10.0 and on each node of the network (whatever their version)
cohabiting with R10.0:
− LIOE and TSC-LIOE boards must be replaced by INTIP or INTIP3 boards.
− INT1and INT2 boards must be replaced by INTOF/INTOF2 boards.
If using Gigabit sets, refer to the technical communication
Ethernet port speed negotiation
release lower than 10.0.
6.1

Installation of Release 10.0 in network with Releases 5.1.x, 6.x, 7.x and 8.0

During the cohabitation period you must prohibit:
− broadcasting of the database and not carry out any audit,
− on the Release 10.0 node, sending of the names in UTF-8 format in the network (set the
Enable UTF8 in ABCF network system parameter to False) if a node is not in a UTF-8
compatible version (see above).
Releases 5.1.x, 6.x, 7.x and 8.x are allowed to cohabite temporarily in a sub-network environment
with Release 10.0 to allow progressive migration, with the following restrictions:
•
The Enhanced Voice Quality (Framing VoIP) parameter must be identical on each
node of the network.
• The LIOE and TSC-LIOE boards are not authorized in heterogeneous network functioning.
•
The H323 Inter-node protocol parameter must be set to Yes.
•
The Direct RTP (in network) parameter must be set to Yes.
•
See table in 7.4.2
• If NGP boards are present in the Release 10.0 node, no faxes exchange via IP will be
possible between this Release 10.0 node and nodes in Releases 5.1.x / 6.x / 7.x, as these
releases don't support the T38 fax mode between Media Gateways.
Note
Release 5.0 Ux cannot cohabite, even shortly, in a sub-network environment with Release 10.0, as it
does not support RTP direct mode in network.
6.2

Installation of Release 10.0 in network Releases 8.0.1, 9.0 and 9.1

Releases 8.0.1, 9.0 and 9.1 are compatible with Release 10.0 in a sub-network environment, with
the following restrictions:
− Minimum compatible versions:
•
R9.1 : I1.605.12
Ed. 02 / 22 June 2011
OmniPCX Enterprise
to know the versions to be used on the nodes in
.
23
TC1090 Wrong IP Touch
TC1449