Spatial Redundancy - Alcatel-Lucent OmniPCX Enterprise Manual

APPENDIX 2
REMARKS & RESTRICTIONS
3.

SPATIAL REDUNDANCY

− In case of CS, the Main and Standby Call Server must not be located in the same rack.
− Do not use SLANX4 but an external switch (LANX16-1 or customer switch) in order to be able to
unplug a Call Server without disturbing other elements.
− The Main and Stand-by CS or Appliance Server can be located in different sub-networks.
•
Features available on AS and CS:
♦ This feature is supported by following IP equipment:
SIP sets
Alcatel series 8 sets (4028-4038-4068)
GD
GA
INTIP
IOIP
"IP Touch Security Module" : SSM, MSM
Attendant IP Softphone
IP CCAgent Softphone
MIPT sets
♦ The applications able to take into account 2 addresses of CPU are:
Alcatel 4635 (R5.2.6)
Alcatel 4645
OmniVista 4760i / 4760 (R3.2)
OmniTouch Contact Center : CCD/CCS/CCA/CCIVR
OmniTouch Unified Communication R4.0
XML Web services
Application "XML IP Touch"
TSAPI
ACAPI
VoWLAN R2.0
•
Features not available on AS and CS:
♦ V1 (4080 RE) - V2 (e-Reflexe IP Phone V2) sets. Only the IP sets of series 8 and SIP sets
are able to take into account 2 addresses of CPU.
♦ Genesys applications (CCEmail, CCOutbound, CCWeb)
♦ RSI Synchro Server
♦ TAPI
•
If a R7.x node is added in a network with nodes less than R6.0, it is essential to continue to
use the addressing by role in case of logical links over IP (the nodes below R6.0 cannot
establish logical links towards two different addresses).
•
If an external DHCP server is used, a tftp server must also be used.
TC1449
OmniPCX Enterprise
INSTALLATION PROCEDURE FOR VERSION
10
J1.410.34.c – RELEASE 10.0
Ed. 02 / 22 June 2011