Int1/Int2 Boards; Negotiation Of Speed Of Ethernet Interfaces - Alcatel-Lucent OmniPCX Enterprise Manual

INTIP3A boards provide up to 120 compressors. If Soft-MSM feature is used, then the maximum
number of compressor is 60.
The V24 console cable for NGP boards is the same as the one used for CS / GD boards.
GD3, GA3, PowerMEX are authorized only in shelves with external battery (rule
taken into account by Actis 15).
In case of shelves with internal battery, Actis will continue to configure GD/GA/MEX
boards.
References of the current Common Hardware media Gateway shelves without internal battery:
Rack module 1 - 110V/230V (without internal battery)
Rack module 1 - 48V (without charger & battery)
Rack module 3 - 230V (without internal battery)
Rack module 3 - 48V (without charger & battery)
The USB connector, present on NGP boards, is not taken into account by the board binary.
NGP boards provide two 10/100/1000 Base-T connectors. Either Ethernet connector can be used
but not both in the same time: currently Ethernet redundancy is not available on NGP boards.
The DIP switch on the NGP boards has not to be modified. The only reason for
which it could be modified on GD/GA boards was to enter in LOLA mode: with NGP
boards, this mode is useless as a flash format is automatically performed when a
network boot is done. Besides this component is quite fragile.

7.7.9 INT1/INT2 boards

In Release 10.0, INT1and INT2 boards must be replaced by INTOF/INTOF2 boards.

7.7.10 Negotiation of speed of Ethernet interfaces

Refer to the technical communication
of Ethernet interfaces for INTIPs, GA & GD after software
TC1449
OmniPCX Enterprise
Designation
TC0680 Risk of wrong negotiation of speed and duplex mode
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
upgrades.
36
Reference
3BA 00404 AB
3BA 00404 AV
3BA 00406 AB
3BA 00406 AV
Ed. 02 / 22 June 2011