Table of Contents
Advertisement
17.3.8 Other (HealthCalcPeriod)
You cannot use the command: HealthCalcPeriod
A period of parts consumption commands information to calculate "remaining months" is
one day and unable to change.
HealthCalcPeriod
HealthCalcPeriod Function Returns the calculation period of parts consumption
17.3.9 Other (ChDisk)
You cannot specify USB option to the command: ChDisk.
17.4 Restrictions of Functions
Some of the following functions are not available.
17.4.1 TP3
You cannot use build of the program. An error occurs to finish the program if executing it.
Other functions are available.
17.4.2 Loop Processing
If the created robot control program is consisted of the multi-tasking and also there are some
task with infinite loop, the system may become unstable and the connection with EPSON
RC+ is disconnected.
The controller detects infinite loop tasks.
detected, the following error occurs and stops the program.
If the error occurs, modify the program and make sure not to set infinite loop.
Error code
Error message
Remedy
There is no problem if executing commands with Wait in the loop such as Wait command,
robot operating command, Print command, and NetWait command.
NOTE: Infinite loop is performed in the following case
T-B series Rev.1
: 2556
: An excessive loop was detected.
Please reduce the number of looped tasks or set Wait
: Do not perform any processing such as infinite loop or any other
similar processing as much as possible.
Execute Wait command or similar command in the loop processing
and avoid occupying the CPU if performing calculation which
required loop or waiting for I/O signals.
When commands are created only with command without Wait in the loop such as
operation instruction, assignment command, and I/O check command.
T3-B T6-B Manipulator 17. Restrictions
Set the calculation period of parts consumption
commands.
commands.
If the possibilities to affect the system are
139
Advertisement
Table of Contents
