Precaution; Software Setup And Connection Check - Epson T-B Series Manual

7.2 Precaution

When connecting the development PC and the Manipulator, make sure of the following:
- Connect the development PC and the Manipulator with a 5 m or less USB cable.
- Make sure that no other devices except the development PC are used for development
- Use a PC and USB cable that supports USB2.0 HighSpeed mode to operate in USB2.0
- Do not pull or bend the cable strongly.
- Do not allow unnecessary strain on the cable.
- When the development PC and the Manipulator are connected, do not insert or remove

7.3 Software Setup and Connection Check

Connection of the development PC and the Manipulator is indicated.
(1) Make sure that software EPSON RC+ 7.0 is installed to the Manipulator connected to
(2) Connect the development PC and the Manipulator using a USB cable.
(3) Turn ON the Manipulator.
(4) Start EPSON RC+ 7.0.
(5) Select the EPSON RC+ 7.0 menu-[Setup]-[PC to Controller Communications] to
(6) Select "No.1 USB" and click the <Connect> button.
T-B series Rev.1
T3-B T6-B Manipulator 7. Development PC Connection Port
Do not use the USB hub or extension cable.
PC connection port.
HighSpeed mode.
other USB devices from the development PC. Connection with the Manipulator may
be lost.
the development PC.
(Install the software when it is not installed. Refer to "EPSON RC+ 7.0 User's Guide".
display the [PC to Controller Communications] dialog.
91