Setting The Transfer Tof - FARGO electronics HDP820 Service Manual

RESTRICTED USE ONLY

Setting the Transfer TOF

This procedure positions the HDP Film correctly on the leading edge of the card. Refer to the
Preparing to adjust the Print Offset, Transfer TOF and Transfer EOF
page 449, for proper sequence.
Step Procedure
1 Choose MENU, Print Test Image and Gray/Align YMC to print a test card.
2 Examine the test card.
•
The Inner Alignment arrows should appear at the edge of the leading edge.
•
The Outer Alignment arrows should not appear on the card, but are shown
here for clarity.
If the test card does not look like the display (below), go to step 5 to adjust the
Transfer TOF.
Outer Alignment
Arrows
TOF
Leading Edge
of Card
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
HDP Transfer Film
Fargo Electronics, Inc.
procedure in Section 8,
Inner Alignment
Arrows
EOF
Trailing Edge
of Card
Continued on the next page
452