Table of Contents
Advertisement
Install the Cameras
1. Use the holes in the base of each camera as a template to mark the screw positions on
the surface where you plan to mount the camera.
2. Using a drill bit slightly smaller than the included screw anchors, drill into the mounting
surface using the guide marks.
3. Insert the screw anchors. Line up the camera base holes with the screw anchors, insert
the screws through the base, and tighten to secure the camera in place. Ensure you
feed the camera wire through the indent in the base as indicated by the green star in the
following illustration.
Add Additional Cameras
You can add additional cameras to your system by following the steps in Step 6. Pair a
Replacement / Add-On Camera.
Congratulations
You are ready to start using your system! Refer to the Live View chapter of this manual to
begin learning more about your system and how it works.
Support.NightOwlSP.com
WNIP2
WNIP-2LTA-BS
WNIP-2LTA-BS-U
DB-WNIP2-SU
BWNIP-2TA-BS
15
- Quick Links:
- Initial Setup
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WNIP2 Series and is the answer not in the manual?
Questions and answers
I have model WNIP-2LTA-BS-U stand alone camera. I previously had this device in use for my garage. we had to change routers and now have different password. I **** not able to get the camera connected
I need help with getting the phone on the App
To connect your Night Owl WNIP2 Series camera to the app:
1. Open the Night Owl Protect app.
2. Tap "Add New" and select "Standalone Camera."
3. Tap "OK" to allow the app to scan the camera’s QR code.
4. Tap "Use Your Network to Discover Your Device," then tap "OK."
5. Tap "Use Your Network to Discover Your Device" again.
6. Tap on the detected device and confirm by tapping "Yes."
7. Go to your device settings, tap "Wi-Fi," and connect to the network starting with "noip."
8. Once connected (checkmark appears), return to the app.
9. The app will search for the camera automatically.
10. Select your Wi-Fi network, enter the password, and tap "Continue."
11. When the screen says "Device has been added" and the camera says "Woohoo," setup is complete.
12. Name the camera and tap "Live View" to see the live stream.
This answer is automatically generated