Table of Contents
Advertisement
9. Verify that you can see your cameras and click Continue.
10. Click Complete Setup. Your Wi-Fi NVR goes to the Live View screen. Proceed to Step 5 -
Install the Cameras.
Disconnected from the Internet
IMPORTANT: Night Owl STRONGLY RECOMMENDS connecting the Wi-Fi NVR to the
Please note the following limitations if you choose to NOT connect the Wi-Fi NVR to the
Internet:
• You must manually update the Wi-Fi NVR firmware to the latest version to receive
Technical Phone Support. Go to
(see the support label on your Wi-Fi NVR to confirm) in the search field to access the
latest firmware. Follow the instructions that are provided with the download.
• You cannot view your system remotely on a Smart Device.
• Resetting your password is a much longer process to ensure security.
BEFORE YOU BEGIN THIS PROCEDURE:
You must have a USB flash drive or External Hard Drive that is formatted to FAT32. Refer
to the Format a USB Flash Drive or External Hard Drive section of the Back Up/Export
Videos chapter for further instructions.
1. Plug your Wi-Fi NVR into a power source.
2. After ensuring you have a formatted USB flash drive or External Hard Drive, click I do not
want to connect to the Internet.
3. At the STOP prompt, after reading the advisory message, click I still don't want to
connect it.
10
Internet for this initial setup.
https://support.nightowlsp.com/
and type "WNIP2"
WNIP2 Series User's Manual
- Quick Links:
- Initial Setup
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WNIP2 Series and is the answer not in the manual?
Questions and answers
I have model WNIP-2LTA-BS-U stand alone camera. I previously had this device in use for my garage. we had to change routers and now have different password. I **** not able to get the camera connected
I need help with getting the phone on the App
To connect your Night Owl WNIP2 Series camera to the app:
1. Open the Night Owl Protect app.
2. Tap "Add New" and select "Standalone Camera."
3. Tap "OK" to allow the app to scan the camera’s QR code.
4. Tap "Use Your Network to Discover Your Device," then tap "OK."
5. Tap "Use Your Network to Discover Your Device" again.
6. Tap on the detected device and confirm by tapping "Yes."
7. Go to your device settings, tap "Wi-Fi," and connect to the network starting with "noip."
8. Once connected (checkmark appears), return to the app.
9. The app will search for the camera automatically.
10. Select your Wi-Fi network, enter the password, and tap "Continue."
11. When the screen says "Device has been added" and the camera says "Woohoo," setup is complete.
12. Name the camera and tap "Live View" to see the live stream.
This answer is automatically generated