Table of Contents
Advertisement
4. Next, you will need to reset the replacement camera. Lift the rubber piece labeled SD/
Reset. Using the included reset pin, press and hold the reset button until you hear a voice
prompt indicating the camera is resetting.
NOTE: The reset process may take up to 3 minutes.
5.
A. After 3 minutes have passed or after hearing the camera beep, click on Wireless Add
located on the Add Camera screen. Your Wi-Fi NVR will now search for new cameras.
B. The replacement camera will not appear in the bottom screen with all other paired
cameras until the Wi-Fi NVR finishes the process of finding and pairing the new camera.
6. Within the Wireless Add screen, the "Connected Cameras" number signifies those
cameras that are already paired to the Wi-Fi NVR and will not immediately reflect this new
camera.
NOTE: You cannot exceed the number of Wi-Fi NVR channels you have. If you have a
Support.NightOwlSP.com
Reset Pin
4 channel system, the maximum number of cameras you can have paired is 4.
17
- Quick Links:
- Initial Setup
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WNIP2 Series and is the answer not in the manual?
Questions and answers
I have model WNIP-2LTA-BS-U stand alone camera. I previously had this device in use for my garage. we had to change routers and now have different password. I **** not able to get the camera connected
I need help with getting the phone on the App
To connect your Night Owl WNIP2 Series camera to the app:
1. Open the Night Owl Protect app.
2. Tap "Add New" and select "Standalone Camera."
3. Tap "OK" to allow the app to scan the camera’s QR code.
4. Tap "Use Your Network to Discover Your Device," then tap "OK."
5. Tap "Use Your Network to Discover Your Device" again.
6. Tap on the detected device and confirm by tapping "Yes."
7. Go to your device settings, tap "Wi-Fi," and connect to the network starting with "noip."
8. Once connected (checkmark appears), return to the app.
9. The app will search for the camera automatically.
10. Select your Wi-Fi network, enter the password, and tap "Continue."
11. When the screen says "Device has been added" and the camera says "Woohoo," setup is complete.
12. Name the camera and tap "Live View" to see the live stream.
This answer is automatically generated