Safety Instructions; Warranty - M&C SP Series Instruction Manual

3

SAFETY INSTRUCTIONS

Follow these safety directions and instructions regarding installation, commissioning and operation of this
equipment:
Read this manual before commissioning and operating the product. Please make sure to follow all safety instruc-
tions.
Installation and commissioning of electrical devices must be carried out only by qualified skilled personnel in com-
pliance with the current regulations.
The installation and commissioning of the device must conform to the requirements of VDE 0100 (IEC 364) 'Regu-
lations on the Installation of Power Circuits with Nominal Voltages below 1000V' and must be in compliance with
all relevant regulations and standards.
Before connecting the device, please make sure to compare the supply voltage with the specified voltage on the
product label.
Protection against damages caused by high voltages:
Disconnect the power supply before opening the device for access. Make sure that all extern power supplies are
disconnected.
Operate the device only in the permitted temperature and pressure ranges. For details please refer to the technical
data sheet or manual.
Install the device only in protected areas, sheltered from rain and moisture. The product should not be exposure to
the elements.
This device is NOT certified to be installed or operated in explosive hazardous areas.
Installation, maintenance, inspections and any repairs of the devices must be carried out only by qualified skilled
personnel in compliance with the current regulations.
4

WARRANTY

In case of a device failure, please contact immediately M&C or your M&C authorized distributor.
We have a warranty period of 12 months from the delivery date. The warranty covers only appropriately used prod-
ucts and does not cover the consumable parts. Please find the complete warranty conditions in our terms and
conditions.
The warranty includes a free-of-charge repair in our production facility or the free replacement of the device. If
you return a device to M&C, please be sure that it is properly packaged and shipped with protective packaging.
The repaired or replaced device will be shipped free of delivery charges to the point of use.
6 SP2000, SP2300, SP2400 | 1.00.03 www.mc-techgroup.com