Receipt Of Goods And Storage; Preparation For Installation - M&C SP Series Instruction Manual

12

RECEIPT OF GOODS AND STORAGE

 The gas sample probe and any special accessories should be removed carefully from the packaging and checked
immediately for completeness against the delivery note.
 Check the goods for any damage incurred during transport and if necessary inform your transport insurer of any
damage.
The gas sample probe is normally delivered in two packaging units:
1. The gas sample probe with the screws, nuts and flange seal required for mounting.
2. Sample tube or prefilter, if applicable with extension tube.
The equipment should be stored in a protected, frost-free room!
Note
13

PREPARATION FOR INSTALLATION

 Select the optimal sampling point in accordance with the generally applicable guidelines or consult the com-
petent persons.
 Locate the sampling point in such a way that there is adequate space for inserting and removing the probe and
pay attention to the insertion length of the probe tube.
 Make certain that the probe is easily accessible so that you can carry out any subsequent maintenance work
without trouble.
 Locate the probe connections in such a way that the connections' temperature is always above the acid dew
point in order to avoid corrosion and blockage problems. If this is not possible, a heated SP35/SP30 probe tube
is recommended for cold connections.
 If the ambient temperature in the area of the connections is > 80 °C [176 °F] as a result of radiated heat, then a
radiated-heat deflector must be mounted to protect the probe.
 The connection's mounting flange connection should comply with DN65 PN6. If other connection sizes are
required, a special adapter flange /S010 can be supplied as an option. Instead of flange connection mounting,
the probe can also be mounted using a /SO1 R2" adapter on a corresponding threaded sleeve connection. This
adapter can be supplied. The necessary minimum flange size and the minimum connection diameter depends
on the diameter of the probe tube or prefilter used.
www.mc-techgroup.com SP2000, SP2300, SP2400 | 1.00.03 17