Saving The Parameterisation Data - Vega VEGASON 61 Operating Instructions Manual

6 Set up with the display and adjustment module PLICSCOM
Service
Basic adjustment
Display
Diagnostics
▶
Service
Info
False signal suppression
Change now?
Reset
Select reset?
HART mode
Standard
Address 0
Info
Basic adjustment
Display
Diagnostics
Service
▶
Info
Instrument type
Serial number
12345678
On paper
In the display and adjust-
ment module
40
4
4.1 Extended setting
►
None
4.5 Unit of measurement
►
m(d)
select?
4.9 Copy sensor data
Copy sensor data?
5
5.1 Date of manufacture
Software version
6.5

Saving the parameterisation data

We recommended writing down the adjustment data, e.g. in this op-
erating instructions manual, and archiving them afterwards. They are
thus available for multiple use or service purposes.
If the instrument is equipped with a display and adjustment module,
the parameter adjustment data can be saved in it. The data remain
permanently stored there even if the sensor supply fails. The proce-
dure is described in menu item " Copy sensor data".
4.2 Current output
Characteristic: 4-20 mA
Fail.mode: < 3.6 mA
Min. current: 3.8 mA
4.6 Language
►
Deutsch
PIN
Enable?
5.2 Last change using PC
VEGASON 61 • Four-wire 4 ... 20 mA/HART
4.3 Simulation
►
►
Start simulation?
►
4.7 SIL
Not activated
5.3 Sensor characteristics
Display now?
4.4
4.8
►
5.4