With Separate Housing - Endress+Hauser Liquicap M FTI51 Operating Instructions Manual

Liquicap M FTI51, FTI52
!
!
Endress+Hauser
3.5

With separate housing

Note!
• The maximum connection length between the probe and the separate housing is 6 m (L4). The desired
length must be quoted when ordering a Liquicap M with a separate housing.
• The total length L = L1 + L4 should not exceed 10 m (e.g. for rope probes).
• If the connecting cable is to be shortened or passed through a wall, it must be separated from the process
connection. See "Documentation" => "Operating Instructions" on
E E X X
Zone 1 Zone 1
Rod length L1 max. 4 m
Rope length L1 max. 9.7 m (the maximum total length of L1 + L4 should not exceed 10 m.)
Extension heights
Housing side: wall mounting
~61 mm B
Note!
The cable has a bending radius of r ≥ 100 mm which may not be undershot!
Page 88
£ £
L4 L4 6 m 6 m
Housing side: pipe mounting
B
~75 mm
Installation
.
E E X X
Zone 0 Zone 0
L00-FMI5xxxx-14-00-06-xx-003
Sensor side
³
r 100 mm
D
³
r 100 mm
L00-FMI5xxxx-06-05-xx-xx-049
35