Return; Disposal; Firmware History; Contact Addresses At Endress+Hauser - Endress+Hauser Liquicap M FTI51 Operating Instructions Manual

Troubleshooting
80
9.3

Return

You must take the following measures before returning a measuring device to Endress+Hauser, for
example for repair:
• Remove all traces of the medium. Pay particular attention to crevices and grooves for seals into
which the medium can penetrate. This is particularly important if the medium is hazardous to
health, e.g. combustible, toxic, caustic, carcinogenic etc.
• Always enclose a fully completed "Declaration of contamination" form with the device (a master
copy of the "Declaration of contamination" form can be found at the end of these Operating
Instructions). Only then can Endress+Hauser check or repair a returned device.
• If necessary, enclose special handling instructions when returning the device, e.g. a safety data
sheet in accordance with EN 91/155/EEC.
In addition, specify the following:
• The chemical and physical properties of the medium
• A description of the application
• A description of the fault that occurred
• Operating time of the device
9.4

Disposal

At disposal, ensure that materials are properly separated and the device components are reused.
9.5

Firmware history

Electronics Release date
FEI51 10/2007
FEI52 07/2006
FEI53 07/2006
FEI54 07/2006
FEI55 11/2008
FEI57s 07/2006
9.6

Contact addresses at Endress+Hauser

On the back page of these Operating Instructions, you can find an internet address for
Endress+Hauser. The web site provides contact addresses that you can use in case of any questions.
Liquicap M FTI51, FTI52
Software version Software change
V 01.00.XX Original software
V 01.00.XX Original software
V 01.00.XX Original software
V 01.00.XX Original software
V 02.00.XX Extended to include SIL
functionality
V 01.00.XX Original software
Endress+Hauser