Wiring
!
!
44
4.3
Wiring in housing T13
To connect the electronic insert to the power supply, proceed as follows:
a.
Unscrew the housing cover (1).
b.
Remove the cable gland (2) and insert the cable (3).
c.
Ground the shield (4) on both sides!
a. + b.
2
3
Note!
The connection shown under (c.) depends on the type of protection ordered. This illustration shows
the terminal module for EEx d. For connection in a separate connection compartment, the same
connection descriptions apply as for the electronic inserts.
Note!
All further steps depend on the specific electronic insert used, and are described on the following
pages:
FEI51→ Page 46
FEI52→ Page 47
FEI53→ Page 48
FEI54→ Page 49
FEI55→ Page 50
FEI57S → Page 51
Liquicap M FTI51, FTI52
c.
1
1 2
L00-FTI5xxxx-04-06-xx-xx-004
Endress+Hauser
4