Northern Telecom M5317TX Installation Manual page 33

14. Press OK to save TEI settings. The display shows:
Voice SPID:
Note that the Clear and <-- softkeys are displayed when a Voice
SPID exists.
15. Enter the SPID for voice service, if required. Use the Clear and <--
softkeys to edit your input, if necessary.
ETSI
Leave Voice SPID blank for ETSI signalling.
If you did not define a data TEI in steps 10 and 11, go to step 22.
16. Press OK.
Data SPID:
17. Enter the SPID for CSD service, if required. Use the Clear and <--
softkeys to edit your input, if necessary.
1B +D
Do not enter a Data SPID. For ETSI and 1B+D
service, the Data SPID must be left blank. If a
Data SPID is shown on the display, press
ETSI
Clear to remove the number.
18. Press OK.
DataDN:
For 1B + D service, you must enter a data DN
1B +D
even though the data TEI and SPID are left
blank. Usually, the Data DN is the same as the
Voice DN. Note: Using a data DN which is
shared with another set is not recommended.
MainROM configuration
M5317TX and CustomNet Installation Guide
23
OK
OK
OK