22
MainROM configuration
Press SwType until the required switch setting is shown:
5.
6.
Press A/Mu until the required encoding law setting is shown:
Press EXIT. The display shows:
7.
VoiceTEI:** DataTEI:
Voice
8.
Press Voice.
9.
Press
If you are not defining a TEI for either circuit-switched or packet-
switched data service, go to step 14.
10. Press Data.
11. Press
If you are not defining a TEI for packet-switched data (PSD), go to
step 14.
12. Press X25.
13. Enter the X.25 TEI.
M5317TX and CustomNet Installation Guide
DMS
For a Northern Telecom DMS switch.
non-DMS
Set for all non-DMS switches.
Auto
To automatically detect the switch type.
NI-1
The Switch setting is used for NI-1 and ETSI
signalling only.
ETSI
Mu-Law
North American installations.
A-Law
Australian and ETSI installations.
•
to enable the voice link.
•
to configure a TEI for circuit-switched data (CSD).
Leave blank for 1B + D configurations-do not
1B +D
press
•
.
X25 TEI:
Data
X25
OK