Table of Contents
Advertisement
2 Preparing to install the M5317TX
This chapter has three sections:
•
•
•
Installation parameters and settings
Before configuring the M5317TX, you need to know about the various
settings required to enable communication with the telephone company
switch. This section describes each type of parameter and setting which
you need to obtain.
If you are a telephone company installer, the service order should
contain all the parameters and settings you need.
If you are an end-user, your telephone company or service provider
must provide the following information:
Signalling type
The signalling type indicates the protocol used by the switch to provide
service to your ISDN line.
The M5317TX can be configured to operate with the following
switches:
•
•
•
Installation parameters and settings discusses the type of
information required to successfully complete the installation
instructions in chapters 3 and 4.
Downloading parameters describes the type of information
required to enable the M5317TX for firmware downloading using
instructions in chapter 4.
Preparing the installation site goes through the tasks you
need to perform before you install the M5317TX.
Northern Telecom DMS-100
Northern Telecom Meridian 1 PBX
other National ISDN-1 compliant switches.
M5317TX and CustomNet Installation Guide
7
Advertisement
Table of Contents
