Initial Start-Up; Assembly; Declaration Of Conformity - Webasto Next Operating And Installation Instructions

The DIP switches should be programmed in such a way
that the output power illustrated below for the single-
and three-phase charging operation can be set to the de-
sired current (D1-D6).
D1 D2 D3 [A] Description
0
0 0 32 Factory settings
0
0 1 10
1
0 0 13
1
0 1 16
0
1 0 20
0
1 1 25
1
1 0 8
1
1 1 0 Demo mode: charging not
possible
D4 0= no unbalance load limit for single-phase
charging,
1= unbalance load limit at 16 A and D1-D3 >
20 A (for CH and AT)
D5 0= no unbalance load limit for single-phase
charging,
1= unbalance load limit at 20 A and D1-D3 >
25 A (for D).
D6 1= TN/TT system
0= IT system (only single-phase connection
possible).

Initial start-up

3.8
Safety check
3.8.1
Document the results of the checks and measurements
carried out during initial start-up corresponding to the
applicable installation requirements and standards.
The local regulations relating to operation, installation
and environmental protection also apply.
3.8.2 Start-up procedure
u Remove material residues from the connection area.
5111233A_ISI_Next
u Check that every screw is correctly tightened and
every clamp is correctly engaged.
Fit the lower cover.
u
u Secure the bottom cover with the mounting screws;
carefully tighten the mounting screws to the stop. See
Fig. 1.
u Switch on power supply.
– Start sequence is activated (duration up to 60
seconds).
– White chase light running up and down. See operat-
ing status N2.
Fig. 6
Perform initial operation check and record measured
u
values in test log. An EV simulator is used for the
measurement at the charging coupling.
Simulate and test the individual operating and protec-
u
tion functions with the EV simulator.
u Connect the charging cable to the vehicle.
– The LED changes from green to pulsing blue.

Assembly

4
Fig. 7
5

Declaration of Conformity

The Webasto Next was developed, manufactured, tested
and supplied in accordance with the relevant directives,
regulations and standards for safety, EMC and environ-
mental compatibility.
Webasto Roof & Components SE hereby declares that the
radio equipment type "Charging Station Webasto Next"
conforms to Directive 2014/53/EU.
The full text of the EU declaration of conformity can be
found at the following web address:
https://webasto-charging.com/documentation.
EN
17